SRMAN 2.4Ghz Mini Remote Control Built-In Lithium Battery With Receiver, Suitable For Electric Skateboard Longboard

SRMAN Board Category: Flat-Plate
Applicable People: Men
Type: Electric Skateboard
Frequency: 2.4Ghz
Battery: 3.7v 500mAh -po Battery
Channel: 2 channel
increase the throttle range about 15%;
add an extra antenna inside to make stronger the signal.
Better quality lithium battery.
Mini Remote Controller 2.4Ghz
Weight: 48g
Frequency: 2.4G
Channel: 2 channels (throttle and LED light)
Application of ESC: All ESC
Power:-po 3.7v 500mAh(included)
Suitable for : Electric skateboard longbaord
USB Charge spot (USB line do not inclueded,as it is suitable for normal USB line)
colour:black
Material:plastic
size:100x52x20mm
Package Contents:
1 * remote control
1 * receiver
1 * USB charging cable

3).Press and hold on the button on the remote and then turn the remote on;
5). you see a solid red light, you now know the two are binded together,and pull the plug out (this is very important,so the remote can record the throttle mid to realize the fail protected)
the transmitter to the receiver? 1).Check and make the entire wires are mounted,and the remote is CLOSED,insert the plug into CH3() on the receiver;2).Switch on the ESC,you’ll see the receiver red light flash;
4).You will have to notice the transimitter go from flashing red to solid red,and also the solid red of the receiver;
6).Then you’ll test it again by turning off the controller and it will have to if you turn the power on Transmitter back on it will have to go back to solid red. running,it is better to test the fail protected fuction by closing the remote,if the motor didn’t move,so the fail protected fuction is in good condition,whilst you find the motor is moving,it’s important to repeat No.1- No.6 above